Control4 CCZ-T1-W Przewodnik Instalacji Pobierz pdf (Strona 17)

Time Format

Date Format: Sets the format preferences for date (MM/DD/YYYY or DD/MM/YYYY).

Time Format: Sets the format preferences for time (12h or 24h).

Sync Time: Synchronizes the time displayed on the Thermostat with the Control4 Controller.

Synchronization automatically occurs daily.

Network

Displays nformational boxes that provide ZigBee networking information (MAC and Firmware

Version).

Select Apply to… to apply the current properties to the selected Wireless Thermostats.

Advanced Device Conﬁguration

Temperature Calibration: Allows calibration of the Thermostat’s reported temperature by +/- 5

degrees. Example: If the Thermostat reads 72 degrees Fahrenheit, and the current temperature

is determined to be 70 degrees Fahrenheit, press the down button two (2) times to lower the

Thermostat reading to 70 degrees Fahrenheit. Select Set Calibration to conﬁrm the change.

NOTE: No changes to calibration should be made within 20 minutes of powering on

the Thermostat. The Thermostat generates a small amount of heat which aects the

calibration. After 20 minutes of continuous operation, this will stabilize allowing

proper calibration.

Heating Cuto Point: Sets the temperature for the heating system to turn o past the setpoint.

To adjust, use the up and down arrows, and then press Set Heat Cuto to conﬁrm the change.

Example: If the Heat Point is set to 68 degrees Fahrenheit, and the Heating Cuto Point is set

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Brak uwag

Control4 CCZ-T1-W Przewodnik Instalacji Strona 17